Machine weight: 600KG
Processing diameter: below 20mm
1 : Hopper 2 : Crusher 3 : Vibration Table
4 : Water Pump 5 : Control Box
1 : All of oil hole must be filled with mechanical butter before operation (once a week)
2 : The water tank must be filled with water
3 : Press the power buttons in the following sequence: water pump/segregating unit/grinder.
Feed water level regulation
1 : Adjust the water level according to the quantity of PVC/rubber particles and copper particles on
the separator plate.
2 : If there are more PVC/rubber particles in copper particles, the water level could be appropriately adjusted higher.
3 : If the PVC/rubber particles don’t go up with copper particles together, the water level could be
appropriately adjusted lower.
The way to replace the screen
1 : Replacing the screen is aimed to increase working efficiency, separating the PVC/rubber particles and copper particles completely.
2 : When replacing the screen, firstly, open the right cover of the grinder; then, loosen the screw of screen to remove it; finally, put the ideal screen into it.
3 : Replacing the screen according to the wire diameter (communication wire: Φ2-2.5mm;
electric wire: Φ2-2.5mm;other wire: Φ3-5mm
4 : Adjustment of the screen: The ideal distance between the screen and the rotary cutter is about 1mm.
The way to sharpen knives
1 : Rotary cutter: Sharpen it by grinder and hold the blade at the ideal 15 degrees. ( No need to
remove the blade).
2 : Stationary knife: Sharp it by grinder or grinding machine after removing the stationary knife.
3 : Knife adjustment: The ideal distance between rotary cutter and stationary knife is about 0.2mm.